![]() Once you’ve completely removed the tile, all you need to do is clean the old thinset off the substrate. Alternatively, you may use a cold chisel or a flat-bladed screwdriver.Įither way, you’ll want to chisel the tile at a 90-degree angle and then switch to a 45-degree angle once you hit the glaze. ![]() It’s best if you use something small like a ball peen hammer so that you have some more control when removing the tile. After drilling the tile, you’ll want to gently tap out its broken pieces using a hammer and chisel. This last part requires a bit of dexterity. This frees the pieces from the substrate, making the tile easier to remove later on. Once you’ve placed the tape, you want to drill evenly spaced holes in the broken part of the tile using your ¼ inch ceramic bit as a guide. This is necessary to protect the other tiles since you’ll have to drill the damaged one. Once you’ve removed the grout, you’ll want to apply some painter’s tape around the edges of the tile. ![]() Apply just enough pressure to remove the grout and scrap it slowly off the tile. Wear your safety goggles and use a grout remover to carefully remove the grout strip from the line. ![]() It’s an important first step as failure to remove it will make replacing the actual tile difficult to do. We’ll start by removing the grout that lines the tile. In this post, Handyman Connection® of Lincoln shares how to properly replace a broken bathroom tile. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |